User`s manual

8-18
IM 701610-01E
• Setting the Source
6. Turn the jog shuttle to move the cursor to the channel to be searched and press
SELECT. (CH3, CH4, and Math2 are not displayed on the DL1620).
• Setting the Level
7. Turn the jog shuttle to set the level and press SELECT. You can use the arrow
keys to move between the digits.
Pressing RESET resets the level to 0 V.
• Setting the Polarity
8. Press SELECT to select
or .
• Setting the Hysteresis
9. Turn the jog shuttle to set the hysteresis and press SELECT. You can use the
arrow keys to move between the digits.
Pressing RESET resets the hysteresis to 0.3 div.
• Setting the Count
10. Turn the jog shuttle to set the count and press SELECT. You can use the arrow
keys to move between the digits.
Pressing RESET resets the count to 0.
• Setting the Start Point
11. Turn the jog shuttle to set the start position of the search. Press SELECT. You
can use the arrow keys to move between the digits.
Pressing RESET sets the position to –5 div.
12. Press ESC to close the search condition setting dialog box.
Setting the Display Position of the Search Results (When Zoom Mode is Z1 & Z2 or
Main & Z1 & Z2)
13. Press the Result Window soft key to select Z1 or Z2.
Executing the Search
14. Pressing the Exec soft key starts the search. The search results are displayed in
the zoomed waveform display position selected in step 13.
You can search 1000 times using the same conditions.
Displaying the Previous Search Results
15. Press the Searched Pattern soft key.
16. Turn the jog shuttle to select the number of the search result to be displayed.
Newer search results are displayed with higher numbers (result 2 is newer than
result 1).
8.10 Search Data Using Search and Zoom Function