User`s manual

8-21
IM 701610-01E
Display
8
• Setting the Source
11. Turn the jog shuttle to move the cursor to the channel to be searched and press
SELECT. (CH3, CH4, and Math2 are not displayed on the DL1620).
• Set the Thr Upper
12. Turn the jog shuttle to set the level used to determine Low and press SELECT.
You can use the arrow keys to move between the digits.
Pressing RESET resets the level to 0 V.
• Set the Thr Lower
13. Turn the jog shuttle to set the level used to determine High and press SELECT.
You can use the arrow keys to move between the digits.
Pressing RESET resets the level to 0 V.
• Set the Pattern
14. Press SELECT to select the pattern number A to D.
15. Turn the jog shuttle to move the cursor to the desired bit position.
16. Press SELECT to select H, L, or X. If you click Clear Pattern all bits are set to X.
17. Set other pattern numbers as necessary.
• Setting the Start Point
18. Turn the jog shuttle to set the start position of the search. Press SELECT. You
can use the arrow keys to move between the digits.
Pressing RESET sets the position to –5 div.
19. Press ESC close the search condition setting dialog box.
Setting the Display Position of the Search Results (When Zoom Mode is Z1 & Z2 or
Main & Z1 & Z2)
20. Press the Result Window soft key to select Z1 or Z2.
Executing the Search
21. Pressing the Exec soft key starts the search. The search results are displayed in
the zoomed waveform display position selected in step 17.
You can search 1000 times using the same conditions.
8.10 Search Data Using Search and Zoom Function