User`s manual

9-30
IM 701610-01E
14. To set User2 through User4, repeat steps 7 through 13 as necessary.
Setting the Measurement Range
15. Press ESC.
16. To set the measurement range of Area1, press the T-Range1/T-Range2 soft key.
17. Set the measurement start point of Area1. If the jog shuttle action is not set to T-
Range1, press the T-Range1/T-Range2 soft key to set the action to T-Range1.
18. Turn the jog shuttle to set the start point of the measurement range.
19. Set the measurement end point of Area1. Press the T-Range1/T-Range2 soft key
to set the jog shuttle action to T-Range2.
20. Turn the jog shuttle to set the end point of the measurement range.
21. Set the measurement range of Area2 in a similar fashion by pressing the T-
Range3/T-Range4 soft key.
9.4 Performing Automated Measurements of Waveform Parameters on Dual Areas