User`s manual

9-36
IM 701610-01E
Scaling
7. Turn the jog shuttle to move the cursor to Scale.
8. Press SELECT to select Auto or Manual. If you select Auto, go to step 15.
9. If you selected Manual, turn the jog shuttle to move the cursor to Center.
10. Press SELECT to display a menu used to set the position of the center in the
waveform display.
11. Turn the jog shuttle to set the position of the center and press SELECT.
12. Turn the jog shuttle to move the cursor to Sensitivity.
13. Press SELECT to display the menu used to set values in 1-div increments.
14. Turn the jog shuttle to set values in 1-div increments and press SELECT.
Note
If you set Center of Sensitivity after setting Scale to Auto, Scale automatically reverts to
Manual.
Setting the Unit
15. Turn the jog shuttle to move the cursor to Unit.
16. Using the keyboard that appears when SELECT is pressed enter the unit using
four characters or less.
Smoothing
17. Turn the jog shuttle to move the cursor to Smoothing.
18. Press SELECT to select ON or OFF.
Note
For details regarding smoothing, see section 9.7, “Smoothing.”
Entering Labels
19. Press the M1 Label soft key to display the keyboard, then enter a label. See
section 8.5, “Setting the Waveform Labels” for information about displaying labels.
Set Math2 in a similar manner as necessary.
9.5 Adding, Subtracting, and Multiplying Waveforms