User`s manual

5-1
IM 701610-01E
Vertical and Horizontal Axes
5
Chapter 5 Vertical and Horizontal Axes
5.1 Turning Channels ON/OFF
Relevant Keys
ACTION DELAY
X - Y
MENU MENU
PHASE
SEARCH
HORIZONTAL
VERTICAL
TRIGGER
TRIG D
HELP
ESC
SELECTRESET
SIMPLE
MODE POSITION
MATH
MISCFILE
CLEAR
TRACE
HISTORY
MEASURE
SETUP
PRESET
DISPLAY
CURSOR
CH 1
CH 2
CH 3
CH 4
POWER
COPY
IMAGE SAVE
SHIFT
ZOOM
GO/NO-GO
ENHANCED
ACQ START/STOP
SNAP
SHOT
V DIV TIME DIV
The DL1620 is not
equipped with
channels 3 and 4.
Operating Procedure
1. Press one of CH1 to CH4 (or CH1 to CH2 for the DL1620) to select the desired
channel.
2. Press the Display soft key to select ON or OFF.
CH1 to CH4 (or CH1 to CH2 for the DL1620) can be pressed twice to turn the
channels ON or OFF.
Explanation
The channels CH1 to CH4 (or CH1 to CH2 for the DL1620) can be displayed
simultaneously.
When turned ON, the indicators to the left of the channel keys light.
Note
• The screen can be split into 1, 2, or 4 display areas (or 1 to 2 display areas). (See section
8.1) A scaling value and waveform label name for each display area (see sections 8.4, 8.5)
can also be displayed.
• If a waveform or waveforms are loaded from history memory, floppy disk, Zip disk, or PC card
the input waveform cannot be displayed. To compare waveforms, use the snapshot function.