Technical data

2400 Series Microwave Synthesizer: Remote Error Messaging
B-2 2400 Series Operation Manual, 33237 Revision A, May 2004
11 List range editing error, start power is out of range.
12 List range editing error, stop power is out of range.
13 List range editing error, step power is out of range.
14 List range editing error, frequency is out of range.
15 List range editing error, dwell time is out of range.
16 System out of memory.
17 Invalid list point parameter.
18 List does not exist.
19 Invalid list trigger repeat type. Single Step, Single Sweep, and Continuous are supported.
20 Invalid list trigger type. BNC, GPIB GET, GPIB Command, and Immediate are supported.
21 Immediate trigger only works with Continuous trigger repeat type.
22 RAMP option is not enabled.
23 RAMP Power span is out of range.
24 RAMP start Power is out of range.
25 RAMP stop Power is out of range.
26 RAMP Frequency span is out of range.
27 RAMP start Frequency is out of range.
28 RAMP stop Frequency is out of range.
29 RAMP time is out of range.
30 Sweep frequency is out of range.
31 Sweep power is out of range.
32 Invalid internal PM polarity. RISing or FALLing are supported.
33 Invalid External PM polarity, NORmal or INVerted are supported.
34 Invalid PM source. INTernal or EXTernal are supported.
35 Invalid PM action. 0 - deactivate, 1 - activate, 2 - activate internal PM, 3 - activate external
pulse negative true, 4 - Activate internal PM, external rising edge trigger, 5 - Activate
internal PM, external falling edge trigger.
37 Modulation option is not enabled.
38 Option 24, internal function generator not installed.
2400 ERROR # 2400 ERROR MESSAGE