Technical data

Front Panel Operation
2400 Series Operation Manual, 33237 Revision A, May 2004 2-9
2.3.7.1.2 Stop Power
Press the Stop Power softkey. Use the numeric keypad, step keys or rotary knob to
enter the stop power level.
2.3.7.1.3 Frequency
Press the Frequency softkey. Use the numeric keypad, step keys or rotary knob to
enter the frequency of the ramp power sweep.
2.3.7.1.4 Sweep Time
Press the Sweep Time softkey. Use the numeric keypad, step keys or rotary knob to
enter the sweep time of the ramp power sweep.
2.3.7.1.5 Attenuation
Press the Attenuation softkey. Using the step keys or rotary knob to enter the attenu-
ation setting. The settable range is 0 to 90, in 10 dB steps. The start and stop power
settings may automatically reset to a permissible level for the attenuation setting. If
option 26 is not present, the display line will display "Option 26 not installed".
2.3.7.1.6 Ramp Freq Menu
Press the Ramp Frequency Menu softkey to enter the Ramp Frequency Sweep menu.
2.3.8 System Menu
The System Menus provide access to the 2400 System information, Memory Storage Locations, GPIB
configuration, display contrast and system volume control. If the current menu is not in the System
menu, press the System Menu button. Press the System Menu softkey at the bottom of the display to
navigate between the system menus.
2.3.8.1 System Menu 1
Save To save the current system configuration to system memory, press the Save softkey to select the
To Register field. Using the numeric keypad, press any value from 0 to 9 and press any units key to
save the instrument configuration.
Recall To recall a previously saved instrument configuration, press the Recall softkey to select the
Recall selection. Using the numeric keypad, enter any available setting number (0 to 9) and press any