Technical data

SCPI Command Set
2400 Series Operation Manual, 33237 Revision A, May 2004 3-5
3.2.5 System Subsystem
[SOURce]:LIST:REPeat
SWEEp|STEP|CONTinuous
Sets the repeat mode for the current list
[SOURce]:LIST:REPeat?
Queries the repeat mode of the current list
[SOURce]:LIST:SEQuence m1, m2,
m3,….., mn
Defines a sequence for stepping through the existing list. The points
specified in this command (m1, m2, m3,…, mn) are indexes into a new
sub-list, and only points in this sub-list will get triggered
[SOURce]:LIST:SEQuence:POINts?
Query the number of points in the sequence list
[SOURce]:LIST:SEQuence:AUTO
ON|OFF
Set list sequence AUTO mode to on or off. When the auto mode is on,
the list sequence will not take effect, so the list will run all of the list
points when it is triggered. When auto mode is off, the list will run only
the points in the sequence. The default is auto mode on
Note: This command is also used to change the 2400 mode from CW or
Ramp to List mode. Example: LIST: SEQ: AUTO ON switches to List Mode
[SOURce]:LIST:SYNC N
Set sync out option . The following is the value of N and its meaning:
N=0, no sync out
N=1, sync out on the first list point
N=2, sync out on the last list point
N=3, sync out on all list points
Command Description
SYSTem:COMMunicate
:GPIB[:SELF]:ADDRess n|MAXi-
mum|MINimum
Set the instrument's GPIB address
SYSTem:COMMunicate
:GPIB[:SELF]:ADDRess?
Queries the instrument's GPIB address
SYSTem:COMMuni-
cate:SERial:BAUD rate
Set RS-232 interface baud rate. Supported rate = 9600, 19200, 38400,
115200
SYSTem:COMMuni-
cate:SERial:BAUD?
Query the current RS-232 interface baud rate
SYSTem:COMMunicate:SERial:BITS
bits
Set RS-232 interface data bits. Bits = 7, 8
SYSTem:COMMuni-
cate:SERial:BITS?
Query RS-232 interface data bits set
SYSTem:COMMunicate:SERial:PAR-
ity[:TYPE] EVEN | ODD | NONE
Set RS-232 interface parity type
SYSTem:COMMuni-
cate:SERial:PAR?
Query RS-232 interface parity set
Command Description