User`s manual

AXIS 262+ Product Description

AXIS 262+ rear panel

RS-232 connector - For the connection of a UPS (Uninterruptible Power Supply) unit. The

approved UPS model is Smart-UPS from APC.

Network connector - Connect the AXIS 262+ to your network using a standard CAT-5

network cable.

9-pin I/O terminal connector - Used to connect external devices, see I/O Terminal

Connector, on page 35 for more information.

Factory setup button - Used to reset the AXIS 262+ to the factory default settings, see

Resetting the AXIS 262+, on page 32.

Power button - To shut the AXIS 262+ down correctly, press and hold this button until a

“beep” sound is heard. Shutdown will then complete after approximately 20 seconds. To

start the unit, press the button once.

Power adapter connector - Connect the power supply cable to the AXIS 262+. The AXIS

262+ starts up automatically after connecting the power supply cable to a power source.

Important!

• Never disconnect the power cable when the AXIS 262+ is on

• Use the power button to switch off the AXIS 262+

RS-232 connector 9-pin I/O terminal

Power button

Power adapterNetwork connector

Factory setup button

connector connector