Installation guide

AXIS T92A00 Installation Guide Page 7
ENGLISH
Connect the power cable to the camera
1. Using the small flathead screw
driver, loosen the screws in the
Power to camera connector on
the connector board (fig.3).
2. Insert the red (+) and black (GND)
wires in the connector and
tighten the screws to secure the
wires.
3. Connect the wires to the green terminal connector on the Axis network camera (fig.4).
4. Proceed to “Route the cables to the housing” on page 8.
Note:
The camera models have different terminal connectors. Be sure to follow the correct description
for the installed camera.
FIG. 4
AXIS 211/211A/211M/211W AXIS 221
AXIS 210/210A AXIS 223M
AXIS Q1755 AXIS P1311
4
FIG.3
+
GND
Power to
camera
+ GND
RS-232
RESET
NETWORK / POWER
POWER
PWR
NET
ACAC
DC+
GND
12345678910
GND +
+ GND
GND +
GND +
GND +