Service manual

12
“” and display will show “PR $##.## B(tray
letter) Row Set”, press “*” to set more prices
or CLR to return to SET PRICES. Press CLR
Key again to return to SERVICE MODE.
3. Single selection. Press the keypad numbers
of the price you wish to use. As numbers are
entered the numbers will shift in from the right
as they are entered. Note: The CLR key will
remove the last # of the price. Once the
desired price is showing on the display press
the selection desired for setting price. Press
“” and display will show “PR $##.## B1
Selection Set”, press “” to set more prices or
CLR to return to SET PRICES. Press CLR
Key again to return to SERVICE MODE.
The last price entered for a selection is the price that
will be used. For example, If one price on the A tray
was set to $1.50 using option 3 above and you wish to
change the remaining selections on that tray using
option 2, the pricing for the entire tray would take
precedence. Conversely, if the price was set using
option 2 first followed by the single selection using
option 3, the pricing for the remainder of the shelf
would remain and the new price for the single
selection would change to the new value.
Press the “CLR” key to return to “SERVICE MODE”.
SET NOT AVAILABLE TIMES
Password protected. Before entering or changing this
setting you must enter the password if one has been
assigned. This mode allows up to 4 different time
periods that use of the machine may be restricted.
To set Not Available Times enter the “SETUP MODE
1” by opening the service door and pressing the
Service Button 3 times. Press the number 3 key; the
display will show “SET NOT AVAIL TIME”. Press the
“” key and the display will show “Select Block (1 –
4): Press number 1 Key to set Select Block 1 available
settings, Key 2 for Select Block 2, etc… Once you
select the Select Block # you wish to set the display
will show “Start MTWTFSS Stop 1 00:00 NNNNNNN
00:00” with the start time hour highlighted. Press the
numbers to enter the hour you wish to start select
block (Note: hour setting is in 24 hour format.) and
then the minutes will be highlighted. Press the
number keys to enter the minutes and then the first
day of the weeks current setting will be highlighted.
To change the setting to no press key 2, to yes press
key 1. This will change each setting left to right one
day at a time until all are set then Stop time hour will
be highlighted. Press the numbers to enter the hour
you wish to stop select blocking and the minutes will
be highlighted. Press the numbers to set the minutes
and the display will show “OK?  = Y CLR = N” press
the  Key to save these settings or CLR Key not to
save settings and display will change to show which
selections are assigned to this block. Press  Key
and display will show “Enter Selection”. Press the
Keys of the selections you wish to disable followed by
 and display will show “Disabled Continue?  = Y
CLR = N”. Note: If you press a tray letter (ie A)
followed by the  Key that entire tray will be set to be
disabled. Once you have selected all settings and the
display shows “Disabled Continue? Or Enabled
Continued? Note: display must show Display
Enabled for the selection to shut down.  = Y CLR
= N (note: pressing clear will delete all settings you
just set), press the CLR to return to “SET NOT AVAIL
TIME”. Press CLR again to return to “SETUP MODE
1”. Once completed go to Test Mode, Not Available
Mode (Key 3) and turn on Not Available Mode.