INSTALLATION GUIDE AXIS A1001 Network Door Controller
Liability Every care has been taken in the preparation of this document. Please inform your local Axis office of any inaccuracies or omissions. Axis Communications AB cannot be held responsible for any technical or typographical errors and reserves the right to make changes to the product and manuals without prior notice.
Safety This product complies with IEC/EN/UL 60950-1, Safety of Information Technology Equipment. The power supply used with this product shall fulfill the requirements for Safety Extra Low Voltage (SELV) and Limited Power Source (LPS) to IEC/EN/UL 60950-1. When used in systems that require UL certification, the product shall be powered by a UL 294-listed or UL 603-listed Class 2 low-voltage power limited power supply.
hardware configuration pages. Use the generated hardware pin chart. Make sure the product is disconnected from power (PoE/DC) while connecting devices to the product. • For information about how to connect other wires, such as power wires to locks, readers and other devices, see the manufacturers’ instructions. Transportation • When transporting the Axis product, use the original packaging or equivalent to prevent damage to the product. Battery The Axis product uses a 3.
AXIS A1001 Installation Guide Page 5 1x 5x 5x 1x Owner Authentication Key The authentication key on this label is used to authenticate the owner/administrator of the product’s unique serial number (S/N), as shown at the top of the label. The authentication key is used for registering the product with an AVHS service provider for hosted services. For more information and help to find a local AVHS Service Provider, go to: http://www.axis.com/products/avhs/ Please keep this document for future reference.
Page 6 1 AXIS A1001 Installation Guide
AXIS A1001 Installation Guide 2 Page 7
Page 8 AXIS A1001 Installation Guide 3 STP STP Power over Ethernet IEEE 802.3af/802.
AXIS A1001 Installation Guide Page 9 4 192.168.0.90 AXIS IP Utility www.axis.
Page 10 5 6 AXIS A1001 Installation Guide
AXIS A1001 Installation Guide 7 Page 11
Page 12 8 AXIS A1001 Installation Guide
AXIS A1001 Installation Guide 9 STP Page 13
Page 14 10 AXIS A1001 Installation Guide
AXIS A1001 Installation Guide Reader I/O connectors DC output: 12 V DC, max 300 mA 2x 4 configurable inputs/outputs: Digital input: 0 to max 40 V DC Digital output: 0 to max 40 V DC, open drain, 100 mA READER I/0 1 &2 Page 15 AWG 28–16 (CSA) AWG 30–14 (CUL/UL) Power & Relay connector DC output: 12 V DC, max 500 mA Relay: 30 V DC, max 700 mA RELAY & PWR Power lock connector 2x 12 V DC 0 V DC, floating, or 12 V DC, max total load: 500 mA LOCK Power connector DC input: 10–30 V DC, max 26 W Max load on out
Page 16 AXIS A1001 Installation Guide 11 STP STP Power over Ethernet IEEE 802.3af/802.
AXIS A1001 Installation Guide 12 Page 17
Page 18 AXIS A1001 Installation Guide 13 T10 www.axis.
Installation Guide AXIS A1001 Network Door Controller © Axis Communications AB, 2013 Ver.1.1 Printed: November 2013 Part No.
