Instruction manual
26 HyTechWorks©2013 – V3.1
Then click on page “Motor Outputs”. Put green ticks in column “Enabled” on “X
Axis”, “Y Axis”, “Z Axis” and “A Axis” row and “Dir LowActive” according to the
requirements. The other columns have no effect on HyCNC-4P’s operation. The
length unit used by Mach3 can be set by operation the main menu
“Config”->”Select Native Units”. The choose “MM’s” or “Inches” as needed.
Finally, the motor operation characteristics need to be set. Operate the main
menu “Config”->”Motor Tuning and Setup”.