Instruction manual

“Control Inputs”). If the input is low level effective, put a green tick in “Active Low”

column. Then click “Apply” and “OK” to save the settings.

The operate the main menu “Config”->”Motor Home/SoftLimits”. The A-axis

settings are used for tool setting operation. If the tool setter is located on the

negative direction on Z-axis (moving negatively to seek tool setter), put a green

tick in column “Home Neg”. “Speed %” defines the % of G0 speed on Z-axis slow

movement. When this setting generates stepping pulses more than 1000Hz, the

accuracy is also affected. In this case, the homing accuracy in theory is

distance per step · pulse frequency

1000