TABLE OF CONTENT Overview Safety Precautions Specifications Installation Location Electrical Installation Diagram Operation Controls How to install an agitator How to install a bowl Attachment use guide Mixing Capacity Maintenance Page Shh
1. OVERVIEW ~The 7 quart mixer has a High 630 Watts power to allow mixing stiffer soughs and larger batches. All metal body and counter-top style is designed professionally. lis shafts are mounted in ball bearing and 100% steel gears drive. Electronic S-speed control helps you to enjoy non-stop shifting speed. «Planetary mixing action and digital timer ensures perfect results. Simple hand Hf is good for changing bowl and attachments. When overloading, power off automatically to protect motor and electrical.
1-2 SPECIFICATIONS Mater: Electrical: Switch & Timer: Cord and Plug: Transmission: Speeds: Safety Guard: Dimension: LxWxH Tet Weight: Standard Attachment: 650 Watts powerful, ball bearing ventilated within mixer enclosure, 100-120V, single phase or 208-240V, single phase All in one digital control panel 6 feet flexible cord and plug (for 110V model only), respectively consist of 3 wires which one wire is connected for grounding, other wires are connected to power supply “The gears are constantly meshed in a
2. INSTALLATION BEFORE INSTALL YOUR MIXER, CHECK TO BE SURE THAT YOUR ELECTRICAL SERVICE SPECIFICATIONS MATCH THOSE OF YOUR MIXER AS PRINTED ON THE MIXER'S NAMEPLATE. 2-1 LOCATION Place the mixer in its operating location. Bench should be placed on a sturdy level surface. There should be adequate space around the mixer for the user to operate the control and install and remove bowls. 2.
3. OPERATION Note: New mixers bowls and agitators (beaters, whip, and dough hook) should be thoroughly washed with hot water and mild soap solution, rinsed with either a mild soda or vinegar solution, and thoroughly rinsed with clean water BEFORE being put into service. This cleaning procedure should also be followed for bowls and agitators before whipping egg whites with or whole eggs.
3-2 HOW TO INSTALL AN AGITATOR To install an agitator, the bowl must be installed and fully lowered. Place the agitator in the bowl, push it up on the agitator shaft, and turn it clockwise to seat the shaft pin in the slot of the agitator shank. 3-3 HOW TO INSTALL A BOWL The bowl must be installed before the agitator. To install the bowl, fully lower the bowl support.
4, MIXING CAPACITY: PRODUCT TOOL | 7 QUART BOWL Egg Whites Whip 700g Mashed Potatoes Beater 1500 Mayonnaise (Qts. Oil) Beater 3 liter Meringue (Qts. Water) Whip 1 liter ‘Waffle/Pan cake Batter Beater 2 liter ‘Whipped Cream Whip 3 liter Sheet Cake Batter Beater 2000 g Layer Cake Beater 2500 g.
5. MAINTENANCE NOTE : ALL MAINTENANCE WORK SHOULD BE DONE ONLY AFTER UNIT HAS BEEN DISCONNECTED FROM ELECTRICAL POWER AND GROUNDING. Never use a metal or stiff brush to clean the mixer. Never clean the mixer with a water hose or any fluid pressure. The mixer should be thoroughly cleaned after using. Bowls and agitators should be removed from the mixer and cleaned. The transmission case and planetary gears are filled special grease that will last for several years.