Manual

ManualsBrandsAxis ManualsCommercial Equipment22.5 Inch 13 Inch blade Meat Slicer

Table Of Contents

1/4

Filename: Man_AX-S_C13N_GB.PMD 14/01/11

AX-S 13G

AX-S C13/N

C33F/N

INSTALLATION

MAINTENANCE

INSTALLATION

UNPACKING

Immediately after unpacking the slicer, check it for possible shipping damage. If you ﬁnd the machine

damaged after unpacking, save the packing material and contact the carrier within 15 days from

delivery.

Before installation, test the electrical service to assure that it ﬁts with the speciﬁcations on the machine

data plate 1 .

ELECTRICAL

Warning: THIS MACHINE IS PROVIDED WITH THIS PLUG . IT MUST BE CONNECTED

TO PROPER GROUND PLUG, GROUNDED OUTLET. IF THERE IS NO GROUND PLUG, CONTACT

AN ELECTRICIAN.

CLEANING

This machine must be thoroughly cleaned and sanitized after installation and before being put into

service.

SAFETY

SAFETY DEVICES INCORPORATED IN THIS SLICER MUST BE IN THEIR

CORRECT OPERATING POSITIONS ANYTIME THE SLICER IS IN USE.

The blade cover 6 must be in position over the knife and secured by tightening the hand knob. 7

The Iast slice device 4 must be used when slicing, it keeps your hands away from the knife.

SLICER

Summary of content (4 pages)

PAGE 1
GB INSTALLATION MAINTENANCE SLICER AX-S 13G AX-S C13/N C33F/N INSTALLATION UNPACKING Immediately after unpacking the slicer, check it for possible shipping damage. If you ﬁnd the machine damaged after unpacking, save the packing material and contact the carrier within 15 days from delivery. Before installation, test the electrical service to assure that it ﬁts with the speciﬁcations on the machine data plate 1 . ELECTRICAL Warning: THIS MACHINE IS PROVIDED WITH THIS PLUG .
PAGE 2
When the slicer is not running, the slicer thickness control 2 must be set on zero (fuIly clockwise) to cover the blade edge. Always UNPLUG the power cord before cleaning or moving the slicer. 10 6 14 3 SLICING 1 PuII the product holder 3 towards you until it stops and place the product to be sliced on the product holder tray. Lay the last slice device against the product and on the slicer 9 switch, press the pushbutton green or 8 red 9 . 2 Adjust the slice thickness rotating the slice thickness control.
PAGE 3
MAINTENANCE Attention Use protection gloves BLADE SHARPENING Your slicer blade will provide long service in normal deli, food store, or commercial kitchen use. Clean the blade removing any greasy residue Make sure that the machine is off. Rotate the slice thickness control 4 to zero to make sure that the blade is covered by the slice thickness plate 5 . 4 1 1 5 Lift the sharpener cover 1 2 Slip off completely the sharpener and spin it 180 degrees. Put the sharpener device.
PAGE 4
Lift and rotate 180 degrees the sharpener and reallocate it into its initial position. Lower the sharpener cover. Cleaning of the grinding wheels To obtain an excellent sharpening the grinding wheel must always be clean. Remove dirt and grease with alcohol and the supplied special brush. 7 8 LUBRICATION The rod on which the product holder slides, which is underneath the slicer, should be weekly properly lubricated. The machine does not have an oiler hole. Lift up the machine and oil the rod directly.