Manual

ManualsBrandsAxis ManualsCommercial Equipment33.5 Inch 14 Inch blade Meat Slicer

FLYWHEEL

SLICER

F300 VO

USE AND

MAINTENANCE

10-02

Turn the flywheel and press

the 8.1 button at the same

time for 10-15 seconds;

Stop rotation and use a pencil

to check whether a slight burr

has formed on the blade edge;

Turn the flywheel again and

press the 8.2 button for 2-3

seconds;

Return the sharpener to its

original position.

Lubrication

dd one or two oil drops at the

points as shown.

Use only the oil supplied with

the machine

After lubrication, clean

carefully and remove the extra

oil if necessary.

8.1

8.2

-8-

-1-

RETURN

Summary of content (4 pages)

PAGE 1
Turn the flywheel and press the 8.1 button at the same time for 10-15 seconds; Stop rotation and use a pencil to check whether a slight burr has formed on the blade edge; Turn the flywheel again and press the 8.2 button for 2-3 seconds; Return the sharpener to its original position. 8.1 8.2 FLYWHEEL SLICER F300 VO Lubrication Add one or two oil drops at the points as shown. Use only the oil supplied with the machine After lubrication, clean carefully and remove the extra oil if necessary.
PAGE 2
Technical features Blade diameter ....................................................................................300 mm Cut thickness ......................................................................................0÷2 mm Cut: -Width .................................................................................................230 mm -Height ................................................................................................
PAGE 3
Extract the tray 6; Clean the its lower part and the carriage 3 surface carefully; 8 9 3 10 7 3 6 6 15 Clean the blade 9 as shown in the image, with great care and starting from the center to the edge; 3 12 15 2 13 9 Open the slice guide 11 and clean inside carefully; 4 1 14 5 8 7 16 10 11 Remove the blade protection 10 after loosening the locking knob. WARNING: Danger of cuts! After cleaning, reassemble the blade protection immediately. -6- 1. Flywheel 2. Handle 3. Carriage 4.
PAGE 4
Machine operation Turn the flywheel 1 drawing the carriage 3 (towards the operator); Pull up the product grip 7; 7 3 Lower the product grip 7 to hold the product; Lower the lever 5 and move it to draw the product near the blade 9; Drawing the product near the blade or away can be carried out more precisely using the knob 14; Set up the slice thickness desired by operating the graduated knob 4 (0÷2 mm); Turn the flywheel 1 to start slicing and placing the slides on the tray 12.