Specifications

and other work under dry conditions. To reduce the generation of static electricity be careful
that the air in the work is not too dry. A relative humidity of 50%-60% is recommended. As
far as possible make the electric potential of your work clothes and that of the work bench
the ground potential.
- The LCD module is coated with a film to protect the display surface. Exercise care
when peeling off this protective film since static electricity may be generated.
1.13 Since LCM has been assembled and adjusted with a high degree of precision, avoid applying
excessive shocks to the module or making any alterations or modifications to it.
- Do not alter, modify or change the shape of the tab on the metal frame.
- Do not make extra holes on the printed circuit board, modify its shape or change the
positions of components to be attached.
- Do not damage or modify the pattern writing on the printed circuit board.
- Absolutely do not modify the zebra rubber strip (conductive rubber) or heat seal
connector.
- Except for soldering the interface, do not make any alterations or modifications with a
soldering iron.
- Do not drop, bend or twist the LCM.
P.17
MULTI-INNO TECHNOLOGY CO.,LTD.
MODULE NO.: MI12864J-G-1
Ver 1.0