User manual

AXIS M3006–V Network Camera
System Op tion s
RTP/H.264
The RTP port range and multicast s etting s are configured under System Options > Network > RTP.
The RTP port range de fine s the range of ports from which the video ports are automatically selecte d. For multicast strea m s, only
certain IP addresses and po rt numbers should be used.
Select Alw ays Multicast Video to start mul ticast stream ing without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
Bonjour can be disabled under System Options > Network > Bonjour .
Storage
SD Card
NOTICE
To prevent corruption of recordings, the SD card should a lways be unmounted befo re it is ejected.
The Axis product supports SD cards with the follow ing file systems:
• ext4 — recom m e nde d due to its resilience against data loss if the card is ejected or if there is abrupt pow er loss. To a ccess
data stored on the card f rom the Window s operating system, a third- party ext4 driver or application is r equired.
• vFAT — most SD cards are pre-formatted with vFAT when purchased.
If required , the SD card can be re-formatted to the desired file system. To format the SD card:
1. Insert the SD card in the SD card slot.
2. Go to System Options > Storage an d click SD Card.
3. Click Format and select the desired file system.
Note
During formatting any pre vious data stored on the disk will be los t.
Mounting is done automatically when the card is inserted or when the product is started . A manual mount is only required if the
card has been unmounted and not ejected a nd re-inserted.
To unmount the SD card:
1. Go to System Options > Storage an d click SD Card.
2. Click Unmount.
3. The card can now be removed.
The SD card is managed on the System Options > Storage page. Click SD Card to open Storage Management.
If the c ard’s status shows as failed, click Check disk to see if the problem can be found and then try Repair. This option is only
available for S D cards w ith ext4. For SD cards with vFAT, use a card reader or computer to troubleshoot the card.
To avoid filling the card, it is recom m e nde d to remove recordings continuously. U nder Recording Settings, select Remove recordings
older than and select the number of days or weeks.
To stop writing to the card and protect recordings from being remove d, select Lock under Recording Settings.
41