Manualshelf

User`s manual

ManualsBrandsAxis ManualshomeM7014
31323334353637383940
AXIS M7014
System Options
To use SNMP v3, HTTPS must be enabled, see
HTTPS, on page 30
. To enable SNMP v3, check the bo x and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product m ust be reset to factory default, see
Reset to Factory Default Settings, on page 39
.
UPnP
TM
The Axis pro duct includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can b e disabled under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range and multicast setting s a re configured under System Options > Network > RTP.
The RTP port range defi ne s the range of ports from which the video ports are automatically selected. For multicast streams, only
certain IP addresses and port numbers should be used.
Select Always M ulticast Video to start m ulticast streaming without opening an RTSP session.
Bonjour
The A xis product includes support for Bonjour. Bonjou r is enabled by default and the product is automatically detected by op erating
systems and clients that support this protocol.
Bonjour can be disabled under System Options > Network > Bonjour.
Storage
SD Card
NOTICE
To prevent corruption of recordings, the SD c ard should always be unmounted before it is ejected.
The Axis product supports SD cards with the following file systems:
• ext4 — recom m e nde d due to its resilience aga inst data loss if the card is ejected or if there is abrupt power loss. To a ccess
data stored on the card from the Windows operating system, a third-party ext4 driver or application is r equired.
• vFAT — most SD cards are pre-formatted with vFAT when purchased.
If required, the SD card can be re-form a tted to the desi red file system . To format the SD card:
1. Insert the SD card in the SD card slot.
2. Go to System Options > Storage a n d click SD Card.
3. Click Format and select the desired fi le system.
Note
During forma tting any previous data stored on the disk will be lost.
Mounting is done automatically when the card is inserted or when the product is started. A manual m ount is only required if the
card has been unmounted and not ejected and re-inserted.
To unmount the SD card:
36