User`s manual

Section 6: Setup for Unix systems
50 Axis NPS 550 User’s Manual
Set up and attach a print queue
The final step is done using the axinstall script, which is up-loaded from
the NPS 550 to your host using FTP. You don’t need any technical
knowledge about your Unix system; axinstall will automatically detect
your system’s characteristics, and guide you through the setup procedure.
Below is a list of Unix systems that are supported by axinstall:
If your particular system isn’t listed, axinstall tries to use one of the
generic Unix systems (BSD, SYS V R3 or SYS V R4). If axinstall fails to
recognize your system, complete the setup manually as described in the
Axis NPS Print Server Technical Reference.
Up-load axinstall 1. Log in to the NPS 550 with the command ftp <host name>, where
host name is the name assigned in your system host table (e.g. sales-
dept). You will be prompted for user id and password. Enter root as
user id, and pass as password.
2. Up-load the script using the command get axinstall.
3. Log out using quit, bye or exit (depending on your FTP version).
*
BSD
(Berkley Unix)
IRIX
(Silicon Graphica, SGI)
SunOS 4
(Sun BSD, Solaris 1.x)
BOS
(BULL DPX 2)
ULTRIX
(Digital Equipment, DEC) *
SYS V R4
(UNIX System V Release 4)
DEC OSF/1
(Digital Equipment, Alpha)
SunOS 5
(Sun SYS V, Solaris 2.x)
FreeBSD
(Berkley Unix)
HP-UX
(HP 9000)
*
SYS V R3
(Unix System V Release 3)
AIX
(IBM RS/6000, BULL DPX 20)
SCO
(Santa Cruz Operation)