User`s manual

Section 7: Setup for Macintosh
54 Axis NPS 550 User’s Manual
Choose a Printer
Choosing a printer is slightly different depending on which version of
LaserWriter printer driver you are using.
The LaserWriter 7.0 driver assumes that you use a standard PostScript
driver, and cannot take advantage of any printer specific features.
The LaserWriter 8.0 driver uses PPD files that contain printer descrip-
tions. This gives you full control over any features your printer might
have.
LaserWriter 7.0
Printer Driver
Open the Chooser window by clicking Chooser in the Apple menu. Fol-
low these steps to choose a printer:
1. Click the LaserWriter icon.
2. If your network has more than one zone, click on the zone you want.
If your network has no zones, this box does not appear.
3. Click the name of the printer you want. The three default NPS 550
printer names are shown as AXIS<nnnnnn>_<port>, where <nnnnnn>
is the last six digits of the NPS 550 serial number, and <port> is LPT1,
LPT2 and COM1 respectively.
Example:
AXIS100086_LPT1
4. Click the close box. This completes the configuration and closes the
Chooser.
Repeat this procedure for each Macintosh using the NPS 550.