User`s manual

Section 2: Getting started
Axis NPS 630/632 User’s Manual 13
Network Installation
1. Switch off the printer and disconnect the external power supply.
2. Record the serial number of your NPS 630/632. You will need this
number for the setup.
3. Slide the RING SPEED switch towards 4 or 16 depending on the
ring speed of your network.
4. NPS 630 only: Connect your NPS 630 to the network using a UTP
(Media Type 3) Token Ring cable.
5. NPS 632 only: Connect your NPS 632 to the network using a STP
(Media Type 1) Token Ring cable.
6. Switch on the printer and connect the external power supply.
Notes: It is not recommended to use standard UTP cabling on 16 Mbit
networks, but screened or foiled Media Type 3 cabling may be used.
Each NPS print server is preconfigured with a unique Node Address
(identical to the serial number). You can change this to a Locally
Administrated Address, see page 65.
The installation is now completed. Proceed with the setup sections for
NetWare, Windows, OS/2 and/or Unix.
Before you begin:
• Make sure that your network is ready to accept a new node.
• Any network configuration should always involve the network
manager.
• Don’t connect or disconnect the network cabling, or change the
Ring Speed setting while the NPS 630/632 is powered on.