User`s manual

Appendix A: The parameter list
Axis NPS 630/632 User’s Manual 69
Factory Default Settings
If you should need to reset the NPS 630/632 to factory default
conditions, the best way to do this is to use the TEST button. This
procedure involves switching the NPS 630/632 off and on. If you use an
external power supply, unplug the power cord to switch off the NPS 630/
632, otherwise use the printer’s power switch.
1. Switch off the NPS 630/632.
2. Press and hold the TEST button while you switch on the NPS 630/
632. Keep the TEST button pressed for at least 20 seconds until the
NETWORK flashes with one second intervals.
3. Release the TEST button and wait at least five seconds (five indica-
tor flashes).
4. Press and hold the TEST button for at least five seconds until the
NETWORK indicator remains constantly lit.
5. Restart the NPS 630/632 (power-off/power-on).
The NPS 630/632 is now reset to factory default conditions.
Note: The Node and Internet Addresses (NODE_ADDR and INT_ADDR)
remain unchanged, but all other parameters are reset to factory default
values.