User`s manual

THE PARAMETER LIST (4214)
Axis AX-3 Cobra+ Technical Reference 108
#071 Form Length Format
This parameter consists of four hexadecimal bytes that together determine how the
form length shall be set in the printer. The meaning of each byte is listed below.
Form Length Format Byte 1:
Form Length Format Byte 2:
Form Length Format Byte 3:
Form Length Format Byte 4:
Note: 1. The default values depend on the selected Printer Driver.
Related
parameters:
#070 Form Length Header
#072 Form Length Tail
Value Description
$01 The form length is set in number of lines
$02 The form length is set in number of inches
$03 No form length setting is done in the printer but parameter #062 is
used to perform form feeds
$04 The Vertical Format Unit method is used to set the form length
$00, $05 - $FF No form length setting is done in the printer and Form Feeds are
simulated with a number of Line Feeds
Value Description
$01 The setting in the printer is done with a binary value (one byte)
$02 The setting in the printer is done with two significant digits of a decimal
value
$03 The setting in the printer is done with a three digits decimal value
$04 If the form length is to be set in number of inches (Form Length Format
Byte 1 = $02), the form length is multiplied by the contents of Form
Length Byte 3 and by 10 before setting is done with decimal digits.
$00, $05 - $FF No form length setting is done in the printer and Form Feeds are
simulated with a number of Line Feeds
Value Description
$00 -$FF If the form length shall be set in number of inches (Form Length
Format Byte 1 = $02), the form length is multiplied with the value of this
byte before setting is done in the printer
Value Description
$00 - $FF This byte is used as an offset that is added to the form length value just
before it is set in the printer