User`s manual

THE PARAMETER LIST (4214)
Axis AX-3 Cobra+ Technical Reference 109
#072 Form Length Tail
After the Form Length Header sequence has been sent to the printer and the form
length value has been set according to the Form Length Format parameter, the Form
Length Tail sequence is sent to the printer.
Note: 1. The default value depends on the selected Printer Driver.
Related
parameters:
#070 Form Length Header
#071 Form Length Format
#075 Quality 1 (Draft Quality)
#076 Quality 2 (Near Letter Quality)
#077 Quality 3 (Fast Draft)
#078 Quality 4
These parameters contain sequences for selection of print quality and are triggered at
power up by the Print Quality parameter or by the Page Presentation Media command
from the host.
Note: 1. The default sequences depend on the selected Printer Driver.
Related
parameter:
#005 Print Quality
#080 Line Density Header
When the Set Line Density command is received from the host, the protocol converter
immediately starts to translate the line density setting from the host to an equivalent
setting in the printer. The first step in that translation is to send the contents of this
parameter to the printer.
Note: 1. The default value depends on the selected Printer Driver.
Related
parameters:
#081 Line Density Format
#082 Line Density Tail
Value Description
<any seq> Last part of the escape sequence for form length setting
<empty> No ending sequence for form length setting is sent to the printer
Value Description
<any seq> ASCII data sequence for selection of print quality
<empty> No selection sequence will be sent (print quality selection disabled)
Value Description
<any seq> First part of the escape sequence for line density setting
<empty> No start sequence for line density setting is sent to the printer