User`s manual

THE PARAMETER LIST (4214)

Axis AX-3 Cobra+ Technical Reference 112

#085 5 CPI

#086 10 CPI

#087 12 CPI

#088 15 CPI

#089 16.7 CPI

These parameters contain sequences for selection of character density and are triggered

at power up by the Character Density parameter, or by the Set Character Density

command from the host.

Note: 1. The default sequences depend on the selected Printer Driver.

parameter:

#002 Character Density

#090 Power-Up Sequence

See “Parameters (3812/5219 Emulation Only)” on page 79.

#091 Micro Step Right

Used by the Printer Drivers for laser printers to accomplish a small displacement of

text when simulated boldface is triggered by a backward positioning from the host.

Note: 1. The default sequence depends on the selected Printer Driver.

#092 Micro Step Left

Used by the Printer Drivers for laser printers to reset the displacement of text, made by

the Micro Step Right parameter, when simulated boldface should be turned off.

Note: 1. The default sequence depends on the selected Printer Driver.

Value Description

<any seq> ASCII data sequence for selection of character density

<empty> No selection sequence is sent (character density selection disabled)

Value Description

<any seq> Sequence for relative move right at simulated boldface

<empty> Simulated boldface disabled

Value Description

<any seq> Sequence for relative move left at end of simulated boldface

<empty> Reset of simulated boldface disabled