User`s manual

EXTENDED EMULATION MODE

AXIS AX-3 Cobra+ Technical Reference 34

Using Extended Emulation Mode

To use the Extended Emulation Mode functions, the Extended Emulation Mode has to

be activated. This is done by inserting the enter Extended Emulation Mode sequence in

your document. Any number of extended emulation functions can then be used before

Extended Emulation Mode is deactivated using the exit Extended Emulation Mode

sequence.

Example: &&??%%P

(enter Extended Emulation Mode) Note 1

(

Configuration Lead-In sequence See page 36)

=120,"UDS STRING 0", $0C

(program parameter #120. See page 36)

=206

(internal function call. See page 37)

(Transp./Config. Trailer Sequence See page 36)

%0C

(Single byte transparency. See page 38)

%%”DATA”0C%

(

Multi-byte transparency. See page 39)

%z0

(Using User Defined Strings. See page 42)

&&??000

(exit Extended Emulation Mode) Note 2

Notes: 1. This is the default enter Extended Emulation Mode sequence. The sequence can be

altered if needed. See also page 35.

2. This is the default exit Extended Emulation Mode sequence. The sequence can be

altered if needed. See also page 35.