User`s manual

EXTENDED EMULATION MODE
AXIS AX-3 Cobra+ Technical Reference 35
Enter Extended
Emulation Mode
The Extended Emulation Mode is entered by inserting the enter Extended Emulation
Mode sequence into your document.
• <EECS> is the Extended Emulation Control Sequence (Parameter #044). The
default sequence is ‘&&??’.
• <Char.1>, <Char. 2> and <Char. 3> are three printable characters to be used for
subsequent extended emulation functions.
Result:
Note: The characters <Char. 1>, <Char. 2> and <Char. 3> must be different from the
characters in the <EECS> sequence.
The example below shows how to enter Extended Emulation Mode.
Result:
Exit Extended
Emulation Mode
To exit the Extended Emulation Mode and to resume normal emulation, the exit
Extended Emulation Mode sequence is used.
• <EECS> is the Extended Emulation Control Sequence (Parameter #044). The
default sequence is ‘&&??’.
Syntax: <EECS><Char. 1><Char. 2><Char. 3>
Param. Title Contents
#040 Escape Character <Char. 1>
#041 Transparency Lead-In Sequence <Char. 1><Char. 2>
#042 Configuration Lead-In Sequence <Char. 1><Char. 3>
#043 Transp./Config. Trailer Sequence <Char. 1>
Example: &&??%%P
Param. Title Contents
#040 Escape Character $6C (%)
#041 Transparency Lead-In Sequence $6C $6C (%%)
#042 Configuration Lead-In Sequence $6C $D7 (%P)
#043 Transp./Config. Trailer Sequence $6C (%)
Syntax: <EECS>000