User`s manual

EXTENDED EMULATION MODE
AXIS AX-3 Cobra+ Technical Reference 36
The example below shows how Extended Emulation Mode can be exited using the
default EECS.
Example:
The parameters for Extended Emulation Mode will be set to their default values (see
Section 9) and the complete parameter list will be saved as well as the
EBCDIC-To-ASCII Character Translation Table.
Configuration from the System
This function enables you to configure the protocol converter without using the
Configuration from a Terminal (described in the User’s Manual). The configuration is
done by including parameter programming commands and internal function calls in
your document. To use these commands the Extended Emulation Mode has to be
invoked (see page 34).
Syntax:
• <CLI>is the configuration Lead-In sequence (parameter #042). The default
sequence is ‘%P’.
• <Parameter/Funct.
n
> are parameter programming commands or internal function
calls.
• <TCT> is the Transparency/Configuration Trailer Sequence (parameter #043). The
default sequence is ‘%’.
Parameter
Programming
The parameter programming command consists of an equal sign, a parameter number,
a comma, and a parameter value. The command is valid only within a configuration
sequence.
Any number of parameters can be programmed before the TCT stop sequence.
Example:
Result: &&??000
Param. Title Contents
#040 Escape Character $00
#041 Transparency Lead-In Sequence <empty>
#042 Configuration Lead-In Sequence <empty>
#043 Transp./Config. Trailer Sequence <empty>
<CLI>=<Parameter/Funct.
1
>[=<Parameter/Funct.
2
>...=<Parameter/Funct.
n
>]<TCT>
Syntax: <CLI>=<Parameter Number>,<Parameter Value or String><TCT>
%P=54,4=120, "UDS STRING 0", $0C % (program parameters #054 and #120