User`s manual

EXTENDED EMULATION MODE
AXIS AX-3 Cobra+ Technical Reference 41
Prescribe
Transparency
For use of Prescribe sequences on Kyocera printers, a special transparency mode is
available. This mode is selected by setting parameter #041 (Transparency Lead-In
Sequence) to $4F, $D9, $4F (‘!R!’). The special transparency mode is triggered by the
text sequence ‘!R!’ and is terminated by any one of the following sequences:
The start and stop sequences will be passed to the printer as ASCII text and the
characters in-between will be converted to their corresponding code in ASCII before
being sent to the printer.
Note: All IBM control codes are ignored during Prescribe Transparency.
FormsXpress
Transparency
The following set-up of the extended emulation parameters is required to enable
printing from FormsXpress. Parameter #040 (Escape character) should be set to $BA
(‘¬’), #041 (Transparency Lead-In sequence) to $BA $BA (‘¬¬’) and #043
(Transparency/Configuration Trailer Sequence) to $5B (‘$’).
Notes: 1. When #040 is set to $BA, the sequences ‘¬R’, ‘¬I’, and ‘¬S’ have special meaning
to the extended emulation handler.
2. All IBM control codes are ignored during FormsXpress Transparency.
3. The parameters controlling simulated bold (#136, Offset for Bold and #137, Reset
Offset for Bold) should be cleared.
EXIT;
EXIT,E;
EXIT, E;
exit;
exit,e;
exit, e;