User`s manual

SOLVING PROBLEMS
AXIS AX-3 Cobra+ Technical Reference 76
Error Messages
There are six different error conditions that causes the protocol converter to print an
error message on your printer.
This message is caused by invalid character codes or LAC buffer overflow.
This message is caused by bad communication lines or colliding device addresses. The
protocol converter will try to re-establish communication after 10 seconds.
This message indicates that an incorrect or insufficient bar code definition has been
used. See Section 5, page 63 and Section 10, page 116 for syntax and examples.
This message indicates that the non-volatile memory has been corrupted. The protocol
converter is automatically set to factory default state (your configuration is lost). This
is a normal consequence of a change between IBM 3812/5219 and IBM 4214
emulation. If the message does not appear after power-off/power-on, configure the
protocol converter. (See user’s manual).
The available string area is exhausted. You must remove some strings from your
configuration (User Definable Strings or String parameters in the Parameter List). The
size of the available string area is printed in the Parameter List header, and is also
displayed in all string programming menus.
Hardware error. Contact your dealer/distributor.
61 - UNPRINTABLE CHARACTER
64 - RESET COMMAND RECEIVED FROM HOST
BE - BAR CODE ERROR
E2 - PERMANENT MEMORY CHECKSUM ERROR, FACTORY DEFAULTS SET
E6 - FREE STRING AREA EXHAUSTED
F1 - TWINAX TRANSCEIVER ERROR