User`s manual

THE PARAMETER LIST (3812/5219)
AXIS AX-3 Cobra+ Technical Reference 82
Related
parameters:
#047 Resend PC-Host String #064 Host-PC Par. String
#060 PC-Host String #065 PC-Host TOF String
#061 Host-PC Ser. String
#040 Escape Character
The EBCDIC International Set 5 character code for Single-Byte Transparency and
User Definable Strings.
Notes: 1. The parameter value must be entered as an EBCDIC character code.
2. The Escape Character is automatically set when the Extended Emulation Control
Sequence is received.
3. For use with the FormsXPress program the escape character should be set to $BA
(‘¬’). The sequences ‘¬R’, ‘¬I’, and ‘¬S’ will then have special meanings to the
extended emulation handler. See also “FormsXpress Transparency” on page 41.
Related
parameter:
#044 Extended Emulation Control Sequence
#041 Transparency Lead-In Sequence
The sequence bypasses the normal emulation and starts a Multi-Byte Transparency
session.
Notes: 1. The Transparency Lead-In Sequence will be automatically set when the Extended
Emulation Control Sequence is received.
2. The sequence must be entered in EBCDIC character codes or literals (e.g.
<$6C,$6C> or </%%/> sets the Transparency Lead-In Sequence to ‘%%’).
3. Maximum 8 characters may be used as Transparency Lead-In Sequence
4. For use of Prescribe sequences on Kyocera printers, a special transparency mode is
available. This mode is selected by setting the Transparency Lead-In Sequence to
$4F, $D9, $4F (‘!R!’). See also “Prescribe Transparency” on page 41.
5. For use with the FormsXPress program the Transparency Lead-In Sequence should
be set to $BA $BA (‘¬¬’). See also “FormsXpress Transparency” on page 41.
Related
parameters:
#043 Transparency/Configuration Trailer Sequence
#044 Extended Emulation Control Sequence
Value Description
$40 - $FF Escape Character (EBCCDIC character code)
$00 Factory default (Escape Character disabled)
Value Description
<TLI> Multi-Byte Transparency start sequence
<empty> Factory default (Multi-Byte Transparency disabled)