User`s manual

THE PARAMETER LIST (3812/5219)

AXIS AX-3 Cobra+ Technical Reference 84

#044 Extended Emulation Control Sequence

The sequence starts and stops Extended Emulation Mode.

Notes: 1. The Extended Emulation Control Sequence must be entered in EBCDIC character

codes or literals (e.g. <$50,$50,$6F,$6F> corresponds to the character sequence

(‘&&??’).

2. The sequence must be followed by three EBCDIC character codes (e.g.

‘&&??%%P’ will start Extended Emulation Mode and ‘&&??000’ will end

Extended Emulation Mode).

3. Maximum 8 characters may be used as Transparency Lead-In Sequence.

parameters:

#040 Escape Character #042 Configuration Lead-In Seq.

#041 Transparency Lead-In Seq. #043 Transparency/Config. Trailer Seq.

#045 Job Time-out

Timer value starting after a host job has ended. If the Time-out value is reached before

any new data has come to the Cobra+, the Start of Job Sequence (#046), Power-Up

Sequence (#090) and current emulator settings will be sent before next job.

parameter:

#046 Start of Job Sequence

The Start of Job Sequence is sent to the printer before next host printout if timer Job

Time-out has elapsed.

parameter:

#045 Job Time-out

Value Description

<EECS> Extended Emulation Control Sequence

$50 $50 $6F $6F Factory default (‘&&??’)

Value Description

0 off (default)

1-255 Time in seconds

Value Description

<any seq.> Start of Job Sequence

<empty> Factory default