User`s manual

THE PARAMETER LIST (3812/5219)
AXIS AX-3 Cobra+ Technical Reference 90
#090 Power-Up Sequence
The Power-Up sequence is sent to the printer when the protocol converter is powered
on.
Notes: 1. The default sequence depends on the selected Printer Driver.
2. The Power-Up Sequence is primarily intended for setting of printer parameters like
emulation and margins, but may also be used for downloading of fonts and logos.
3. The Power-Up Sequence is sent before the warm start sequences.
#095 Sheet Feeder 1
#096 Sheet Feeder 2
#097 Sheet Feeder 3 (Envelope)
#098 Sheet Feeder 4
#099 Single Sheet
These parameters are used for selection of paper source in the printer.
Note: 1. The default sequences depend on the selected Printer Driver.
#100 Simplex
#101 Duplex Normal
#102 Duplex Tumble
These parameters control duplex printing and selects one of the three modes in the
printer on request from the host.
#103 Portrait
#104 Landscape
Parameters for control of print orientation.
Value Description
<any seq> ASCII data sequence to be sent at power on
<empty> No sequence sent at power on (Power-Up Sequence disabled)
Value Description
<any seq> ASCII data sequence for selection of paper source
<empty> No selection sequence will be sent (sheet feeder selection disabled)
Value Description
<any seq> ASCII data sequence for selection of simplex/duplex
<empty> No selection sequence will be sent (simplex/duplex disabled)
Value Description
<any seq> ASCII data sequence for selection of portrait/landscape
<empty> No selection sequence will be sent (portrait/landscape disabled)