Installation guide

Page 16 AXIS P33-VE Series Installation Guide
Prepare the Unit Casing (routing cables along the wall)
If the cables are to be routed along the wall, prepare the unit casing as follows:
1. Detach the side lid that is attached to the unit casing by removing the screw.
2. Loosen the two screws on the cable shield and detach the bottom part.
3. Attach the bottom part of the cable shield to the unit casing with the screw.
Replace Clear/Smoked Dome Cover (optional)
The AXIS P3346-VE/P3367-VE/P3384-VE is supplied with an optional dome.
To replace the dome cover:
1. Loosen the 4 screws under the dome cover that hold the dome in place.
2. Replace the old dome with the new and tighten the screws.
Mounting Bracket
The mounting plate has 4 mounting hole patterns (A,B,C,D).
The mounting hole patterns follow standard for the following
mounting options:
• A: 4" square box
• B: standard-sized US double gang junction box
• C: 4" octagon box
• D: standard-sized US single gang junction box
Side lid
Screw
Top part
Bottom part
Unit casing Cable shield
Unit casing