User manual

AXIS P7210 Video Encoder
Hardware overview
Hardware overview
7
8
9
1
2
34
5
6
10 11
12
13
14
15
1
Power connector
2
microSD card slot
3
I/O connector
4
RS-485/RS-422
5
Control button
6
Network connector (PoE)
7
Audio input 1
8
Audio input 2
9
Audio output 1
10
Video inputs
11
LED indicators
12
Group 1 (4 video input connectors)
13
Group 2
14
Group 3
15
Group 4
Connectors
Network connector - RJ-45 Ethernet connector. Sup
ports Power over Ethernet (PoE). A shielded network cable (STP) must be
used to protect the product against power surges.
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system o r an active speaker
with a built-in amplifier. A stereo connector must be used for the audio out.
SD card slot - Astandar
d or high-capacity SD card (not included) can be used for local recording with removable storage. For
instructions on how to insert and remove an SD card, please refer to the Installation Guide.
Note
Before removal, the SD card should be unmounted to prevent corruptio n of recordings. To unmount the SD card, go to Setup
>SystemOptions>Storage>SDCardand click Unm ount.
Control button - The control button is used for:
• ConnectingtoanAXISVideoHostingSystemservice.Seepage 35. To connect, press and hold the button for about
1 second until the Status LED flashes green.
4