Installation guide

AXIS P7214/P7210 Installation Guide Page 7
ENGLISH
Install the hardware
Important!
The casing of the AXIS P7214/P7210 is not approved for outdoor use - the product may only be
installed in indoor environments.
Notes:
• The AXIS P7214/P7210 can simply be placed on a flat surface or mounted. See below for mounting
instructions.
• Punch out the protective pads and stick them to the underside of the video encoder to prevent scratches on
the surface where the video encoder is placed.
Mount the video encoder (AXIS P7214)
The video encoder is supplied with a mounting kit containing screws and plugs for mounting the
video encoder on a concrete wall:
1. Place the video encoder against the wall, and mark the four mounting holes (see image on
page 6).
2. Drill the four mounting holes.
3. Insert the provided wall plugs into the wall, and attach it to the wall using the screws provided.
Mount the video encoder (AXIS P7210)
The video encoder is supplied with a mounting kit containing brackets and screws. The unit can be
mounted in a rack or on a wall:
After removing the existing 4 screws, attach the mounting bracket to the video encoder at an angle
suitable for installation in a standard 1U 19” rack, or on the wall.
Note:
Each bracket must be attached to the appropriate side of the video encoder, and at an appropriate
angle depending on whether it is mounted on the wall or in the rack.
AXIS P7210 on wall AXIS P7210 on rack
Mounting bracket
Group 1
Group 2 Group 3
Group 4
Bracket position for rack mount
Bracket
Bracket position for wall mount
This side up
This side up