User`s manual

AXIS P7214 Video Encoder

System Options

The following traps are available:

•Coldstart

•Warmstart

•Linkup

• Authentication failed

SNMP v3 provides encryption and secure passwor ds. To use traps with SNMP v3, an SNMP v3 management application is required.

To use SNMP v 3, HTTPS must be e nabled, see HTTPS, on page 33. To enable SNMP v3, check the box and provide the initial user

password.

Note

The initial password can only be set once. If the password is lost, the Axis prod uct must be reset to factory default, see

Reset t o factory default settings, on page 43.

UPnP

The Axis product includes supp ort for UPnP

.UPnP

is enabled by default and the product is automatically detected by operating

systems and clients that support this protocol.

UPnP

can be disabled under System Options > Network > UPnP

RTP/H.264

The RTP port range and multicast setting s are conﬁgured under System Options > Network > RTP.

The RTP port range deﬁnes the range of ports from which the video/audio ports are auto

matically selected. For multicast streams,

only certain IP addresses and port numbers should be used.

Select Always Multicast Video and/or Always Multicast Video to start multicast streaming w ithout opening an RTSP session.

Bonjour

The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating

systems and clients that support this protoc

ol.

Bonjour can be disabled under System Op

tions > Network > Bonjour.

Storage

SD card

The SD/SDHC memory card (not included) is managed on the System Options > Storage page. C lick SD card to open Storage

Management.

Mounting is done automatically when the card is inserted or when the product boots. SD cards are normally preformatted when

purchased, but if needed, click Format to format the card.

Format an SD card so that it can be w ritten to one of two available options — VFAT and ext4. During the formatting any previous

data stored on the disk will be lost. The re c omme nded format is ex t4, due to its res ilie nce against data loss if the card is ejected

or if there is abrupt p ower loss. A third-party ext4 driver or application is also needed to access the ﬁle system from Windows.

Note that most SD cards are pre-formatted with vFAT w hen purchased. The Chec k D isk o ption is used to check for errors on the SD

card and only works for the ﬁle system ext4. The Repair option repairs the SD card o f errors in the ﬁle system ext4. For vFAT ﬁle

system use a card reader or PC to perform card maintenance.

Note

To prevent corruption of recordings, the SD card should always be unmounted before removal.