User`s manual

AXIS P7214 Video Encoder
System Options
The following traps are available:
•Coldstart
•Warmstart
•Linkup
Authentication failed
SNMP v3 provides encryption and secure passw ords. To u se traps with SNMP v3, an SN MP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see
HTTPS, on page 34
. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to Factory Default Settings, on page 44
.
UPnP
TM
The Axis pro duct includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can b e disabled under System Options > N etwork > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings are congured under System Options > Network > RTP.
The RTP port range denes the range of ports from which the video/audio ports are auto
matically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select Alw ays Multicast Video and/or A lwa ys Mu lticast Audio to start multicast stream i n g with ou t open in g an RTSP se ssion .
Bonjour
The A xis product includes support for Bonjour. Bonjour i s enabled by default and the product is automatically detected by operating
systems and clients that support this protoc
ol.
Bonjour can be disabled under System Op
tions > Network > Bonjour.
Storage
SD Card
NOTICE
To prevent corruption of recordings, the SD c ard should always be unmounted before it is ejected.
The Axis product supports SD cards with the following le systems:
ext4 recom m e nde d due to its resilience aga inst data loss if the card is ejected or if there is abrupt power loss. To access
data stored on the card from the Windows operating system, a third-party ext4 driver or application is r equired.
vFAT most SD cards are pre-formatted with vFAT when purchased.
If required, the SD card can be re-formatted to the desired le system. To format the SD card:
1. Insert the SD card in the SD card slot.
2. Go to System Options > Storage an d click SD Card.
40