User manual

AXIS P7224
System Options
The following traps are available :
•Coldstart
•Warmstart
•Linkup
• Authentication failed
SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 30. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial passwo rd can only be set once. If the password is lo st, the Axis product must be reset to factory default, see
Reset to factory default settings, on page 39.
UPnP
TM
The Axis product includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disabled under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range a nd multicast settings a re configured under System Options > Network > RTP .
The RTP port range defines the range of ports from which the video/audio ports are auto
matically selected . For multicast streams,
only certain IP addresses and port numbers should be used.
Select Always Multicast Video and/or Always Multicast Video to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protoc
ol.
Bonjour can be disabled under System Op
tions > Network > Bonjour.
Ports & Devices
I/O Ports
COM Port
The video encoder has one RS-485/RS-422 serial port. The port suppo rts the following modes:
• Generic HTTP allows the video encoder to receive data and send commands via HTTP.
• Pan Tilt Zoom is used to control a PTZ device. The PTZ device requires a driver. See for more information. Drivers can be
downloaded from www.axis.com
• Generic TCP/IPallows the A xis product to receive data and send commands via TCP/IP. Daisy chain server - Allows Daisy
chain c lients to communicate with the Axis product. See also RS-485/RS-422 connector, on page 43.
Select the desired Port Type from the drop-down list. For m ore information on Serial Port Settings and Daisy Chain Port Settings
seetheonlinehelp
.
36