User`s guide

AXIS 70U/7000 User’s Guide Basic Installation

The tri-colored Network indicator displays:

Assigning an IP Address to the AXIS 70U/7000

Follow the instructions below to set the IP address from the Control Panel.

Important!

1. Power up the AXIS 70U/7000 and press Menu when this message

appears:

2. After a few seconds this display will be shown:

3. Press Select to edit the IP address:

4. Press Menu to move through and highlight each digit, one at a time.

5. Use to increase or decrease each highlighted digit, as required.

Flashing Yellow Indicating network activity on a 10MB Ethernet network.

Flashing Green Indicating network activity on a 100MB Ethernet network.

Red Indicating that the unit is not correctly connected to the network.

• This section can be ignored

if you are using DHCP, RARP or BOOTP, as the IP address is set auto-

matically (DHCP is the preferred method for Windows networks, as it automatically sets some

other parameters as well).

• A valid and unused IP address must be acquired from your Network Administrator.

• Connecting a PC-AT keyboard directly to the mini-DIN connector on your AXIS 70U/7000 pro-

vides a convenient method for managing the unit, and setting the IP address during system

start up. The administrator can choose to disallow this function from the Administration pages.

Please make sure that the AXIS 70U/7000 power supply is disconnected before connecting the

keyboard.

• The IP address for your product can also be set using the AXIS IP Installer (available at the Axis

Web site at http://www.axis.com), or the ARP, RARP, BOOTP or DHCP methods.

Please refer to the AXIS 70U/7000 User’s Manual for further details.

AXIS 70U

version: x.xx

IP Address:

000.000.000.000

Edit IP Address:

000.000.000.000