User`s guide

Using the AXIS 70U/7000 AXIS 70U/7000 User’s Guide

Using the AXIS 70U/7000

The services provided to normal users are determined by the administrator

when configuring the product. This section describes all services that can be

made available to a user, namely:

• Sending to destinations.

• Adding temporary e-mail destinations.

• Viewing the images.

• Specifying a sender.

Note:

Sending to Destinations

Follow the instructions below to send information to one or several e-mail

destinations — directly from the AXIS 70U/7000 control panel:

1. The AXIS 70U/7000 is ready for use when the following message is dis-

played:

Where xxxxxx is the destination name.

Note:

2. Use the scrolling keys to find your required destination in the

list. Press and hold the key to autorepeat scrolling. If you want to add a

temporary e-mail destination, refer to Adding E-mail Destinations, on page

21.

3. If you want to send the image to more than one destination, press Select

to choose each destination:

4. Repeat steps 2 and 3, until all desired destinations are selected.

Administration instructions for setting user privileges are provided in Specifying System Settings, on

page 18.

Send to:

xxxxxx

If the AXIS 70U/7000 asks for a User Name, your administrator has enabled authentication and you

must enter your user name and password. For further information, please refer to the AXIS

70U/7000 User’s Manual at the Axis Web site http://www.axis.com

Send to: +13

Accounting Dept