User`s manual

Print Server Management
22 AXIS OfficeBasic USB Wireless G
network management of the print server.
SNMP Trap Settings: Displays SNMP traps sent from the print server.
Send SNMP Traps: Displays if the print server’s ability to send SNMP Traps is
Enabled or Disabled.
Use Authentication Traps: If Enabled, an authentication failure trap is sent to
the trap destination address if you have entered the wrong trap community.
Trap Address 1: Displays the first IP address to which SNMP traps are sent. It
corresponds to the trapAddress SNMP object.
Trap Address 2: Displays the second IP address to which SNMP traps are sent.
It corresponds to the trapAddress SNMP object.
Setup
All print server parameters are configured from the Setup menu. From here the
Network Administrator can edit settings that govern System, Printer, TCP/IP,
SNMP, AppleTalk, etc.
System Print Server Name: Enter a name for the print server if you wish.
If nothing is specified, the default print server name is AXISXXXXXX, where X
represent the last 6 digits of the print server’s serial number. The serial number
can be found on the label on the underside of the print server
System Contact: Enter the name of the contact person in charge of the print
server if you wish.
System Location: Enter a descriptive name for the physical location of the
print server if you wish. Example: “Room A, color printer”.
Password: Enter an access password for the print server’s web pages if you
wish. The default password is pass. The default user name is root.
Wireless Setup
Basic Settings Mode: Select the wireless setting mode you wish to use in your network.
• Infrastructure (Workstations and laptops communicate over the WLAN and
the LAN through an Access Point with the print server).
• Ad-Hoc (Workstations and laptop computers communicate directly over
the WLAN with the print server).
Select SSID: Select or manually enter an SSID. Click Site Survey to scan your
wireless network for available Access Points.
Default SSID in Infrastructure mode = <ANY>
Default SSID in Ad-Hoc (Diagnostic) mode= WLAN-PS.
All print server settings have default values that have been carefully selected
by Axis. In most instances, there is no need to change these default values.