Instruction manual

Precautions
1. AC Fuse - The AC fuse inside the unit is not user-
serviceable. If you cannot turn on the unit, contact
the dealer from whom you purchased this unit.
2. Care - Occasionally you should dust the unit all
over with a soft cloth. For stubborn stains, use a
soft cloth dampened with a weak solution of mild
detergent and water. Dry the unit immediately
afterwards with a clean cloth. Don’t use abrasive
cloths, thinners, alcohol, or other chemical
solvents, because they may damage the finish or
remove the panel lettering.
3. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST
TIME, READ THE FOLLOWING SECTION
CAREFULLY.
AC outlet voltages vary from country to country.
Make sure that the voltage in your area meets the
voltage requirements printed on the unit’s rear
panel. (e.g. AC 90V – 240V 50/60HZ)
The power cord is used to disconnect this unit from
the AC power source. Make sure that the plug is
readily operable (easily accessible) at all times.
If you do not intend to use the unit for an
extended period, remove the power cord from the
AC outlet.
4. Earth – The unit is defined as Class1 in EN60065
(low voltage directive) and MUST BE EARTHED.
Connect only to a mains socket outlet with
protective earth, and only use the power cord
supplied.
Finland:
“Laite on Liitettävä suojamaadoituskoskettimilly
varustettun pistorasiaan”
Norway:
“Apparatet må tilkoples jordet stikkontakt”
Sweden:
Apparaten skall anslutas till jordat uttag”
5. Never Touch This Unit With Wet Hands –
Never handle this unit or its power cord while your
hands are wet or damp. If water or any other
liquid gets inside this unit, have it checked by your
Axium dealer.
6. Handling Notes
• If you need to transport this unit, use the
original packaging to pack it how it was when
you brought it.
• Do not leave rubber or plastic items on this
unit for a long time, because they may leave
marks on the case.
• This unit’s top and rear panels may get warm
after prolonged use. This is normal.
• If you do not use this unit for a long time, it
may not work properly the next time you turn
it on, so be sure to use it occasionally.
7. Speaker Shorts
Under no circumstances should the speaker output
terminals of the unit be short circuited, grounded
or connected to another output.
8. Direct Sun light - Avoid installing the amplifier in
positions where the front panel is exposed to direct
sunlight – may cause control to become sluggish.
9. Controller Connection - Never connect more
than eight Axium controllers. The supply is
internally fused (self resetting) and may open
circuit. Never connect the unit’s 12VDC terminal
(‘Bus Run’ port) to an external power supply.
3