VM-2370CF/VH-11 SPRUCE PROFESSIONAL VIDEO MONOPOD QU I CK-STA RT GU I D E
OVERVIE W Q ui c k- R e l e a s e P l a t e (Q R P - 6 01) 1. Camera mounting stud: 1/4 and 3/8 in. 2. Registration pin 3. Camera pads F l u i d V i d e o H e a d ( V H -1 1 ) 4. Left- and right-handle sockets 5. Plate receiver 6. Accessory sockets: 1/4 and 3/8 in. 7. Quick-release plate safety button 8. Tilt adjustment locking knob 9. Bubble level 10. Quick-release plate locking knob 11. Pan handle locking knob 12. Pan handle 13. Handle extension twist lock 14.
1 2 3 4 6 5 7 4 10 8 11 6 9 13 12 15 14 17 16 19 18 21 20 Also Included: • Padded carrying case with zippered pocket • Shoulder strap • 3 mm hex key 22 23 25 24 28 27 26
THANK YOU FOR CHOOSING A XLER. The Axler VM-2307CF Spruce is a professional four-section video monopod with a fluid head. This monopod provides you with twist locks to quickly extend each section up to 80 in. (203 cm) for overhead shots, or collapse the monopod down to 28 in. (71 cm) for low-angle shooting. Three locking feet help the monopod to reinforce stabilization, which can lessen the stress on your arm when holding your camera rig for long hours.
Q U I C K - R E L E A S E P L AT E The quick-release plate allows you to speedily mount and dismount your camera with 1/4 in. and 3/8 in. mounting studs. The studs can be stored in the appropriate accessory sockets when not in use. 1. Loosen the quick-release plate locking knob. 2. Press the safety button, and slide the plate out of the receiver. 3. Attach the quick-release plate to the bottom of your camera, using either of the mounting studs. 4.
V IDEO PA N H A NDL E The handle can be used on either side of the fluid head and is able to extend to allow for better camera handling. 1. Rotate the handle’s twist lock clockwise to loosen. 2. Extend the handle. 3. Rotate the twist lock counterclockwise to tighten. USING THE MONOPOD FEE T To reinforce stabilization, flip out the feet until they lock into position. The feet have an integrated ballhead. To move the monopod on its vertical axis: 1. Loosen the pivot locking wheel. 2.
REPL ACING THE HE AD You can switch out or replace the fluid head with the included 3 mm hex key: 1. Use the 3 mm hex key to loosen (but not remove) all of the three screws underneath the baseplate, It may be necessary to rotate the wrist strap out of the way to expose all of the screws. 2. Rotate the head counterclockwise to remove it. 3. Seat the replacement head onto the mounting stud, and rotate clockwise until secure. If necessary, you can reverse the 1/4 in. or 3/8 in.
THREE-YEAR LIMITED WARRANTY This Axler product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of Three (3) years from the original purchase date or thirty (30) days after replacement, whichever occurs later.