Instruction manual

Assembly

Slide cast iron disc (G) onto the drive shaft, making sure that the clamping screw lines up with

the hole pre-drilled at the top guard moulding (F). Slide a phillips screwdriver down the hole and

tighten the screw, clamping the disc to the shaft (See ﬁgs 23,24 and 25).

Locate the dust extraction moulding (C), line up the pre-drilled holes with the holes in the guard

moulding (F), push the extraction moulding (C) up against the guard moulding (F), so it clips to

the guard. Put to hand the two M5 x 8mm phillips screws, ﬁnger tighten lightly into the holes and

using a phillips screwdriver tighten the screws. DO NOT OVER TIGHTEN (See ﬁgs 26,27 and 28)

Fig 27

Fig 28

Fig 23

Fig 24

Fig 25

Fig 26

Pre-drilled hole

Slide a phillips

screwdriver

down the hole

and tighten the

screw to clamp

the disc.

Phillips screw