Instruction manual

Assembly

Fig 17

onto the end of the motor shaft, line up the holes in the

linisher and secure in place with the four M6x10mm Hex

screws (L) and tighten using the supplied 5mm Hex key (P)

(see ﬁgs 15-16).

Step 3 Loosen the three nuts clamping the linisher

mounting plate and raise the linisher into the upright

position, with the index pointer reading 90˚ on the scale.

Retighten the nuts, see ﬁgs 17.

Step 5 Locate the linisher guard cover (D), the four

M6x10mm socket button head screws (M), the small M6 star

knob (N) and the two M6 large star knobs (O). Position the

guard cover (D) over the lower section of the linisher and

lineup the pre-drilled holes, see ﬁg 21. Screw two M6 screws

Fig 21

Fig 20

Fig 18

Fig 19

(M) in the lower two holes to the right side of the linisher,

see ﬁg 22 close the hinged door, screw one of the M6 large

knobs (O) through the pre-drilled hole above the bearing

assembly (H) and into the linisher (C), screw the small M6

knob (N) into the lower hole, see ﬁg 23.

Fig 22

Step 4 Raise the belt tensioning lever, see ﬁg 18 locate the

linisher’s sanding belt (I), unroll the belt and slide the belt

over the drive rollers and adjust until central, see ﬁg 19.

Lower the belt tensioning lever, see ﬁg 20.

Continues Over...