Specifications

10
ALWAYS disconnect the machine if you are leaving it unattended.
NEVER leave the vicinity of the machine unless the blade has come to a complete stop.
DO NOT attempt to carry out any maintenance, corrective work, setting up etc., unless the
machine is disconnected from the mains supply.
If any tools have been used during setting up procedures, make sure they are removed
from the machine and stowed safely away.
DO NOT attempt to carry out cross cutting operations 'freehand', always use the mitre fence
for small stuff and the sliding carriage for larger work pieces.
Unless you are an experienced machine operator, do not attempt to 'rip' freehand, always
use the guiding facility of the rip fence.
It is perfectly acceptable to support guide and feed the timber with your hands whilst
ripping stuff of some length, however, as you approach the blade ensure that the push stick
is to hand, and you use it.
REMEMBER the emphasis of the 'push' should be between the blade and the fence and
close to the fence. Use your free hand to support and guide the material on the offside of
the saw blade and at least 100mm away from it. If the timber does not extend to at least
100mm to the offside of the saw blade, the material possibly? does not need guiding or
supporting.
CHECK (especially on site), that there are no foreign objects e.g. old nails, screws, small
stones etc embedded in the material you are about to cut. If necessary take a wire brush to
the timber before working.
If you are being assisted whilst using the saw (by a 'take off' or 'support' number?),
remember there is only one sawyer at a machine, and they stand in front of it. The assistant
does not push, pull, guide etc., unless specifically asked or instructed to do so by the
sawyer.
Specific Instructions/Precautions for the Saw Table
Specification
Model TS-200 Basic
Rating Hobby
Power 1,100W
Blade Dia/Bore 200mm/30mm
Blade Tilt 0°-45°
Max Depth of Cut @ 45˚ 40mm
Max Depth of Cut @ 90˚ 58mm
Max Crosscut 620mm
Max Ripping Width 150mm standard, 750mm with R/H Table Kit
Table Size 535 x 400mm
Table Height 320mm
Dust Extraction Outlet 100mm
Min Extraction Airflow Required 500m³/hr
Overall L x W x H 535 x 400 x 325mm
Weight 55kg