Specifications

Assembly Instructions

With assistance, place the Saw Bench (A) onto the stand. Align the four mounting

holes at the base of the Saw Bench with the four mounting holes at each corner

of the stand. Using four M8 x 11mm hex bolts, large washers & nuts (T) secure

the Saw Bench to the stand. (See fig 5 & 5a).

Attaching the Saw Bench to the Stand

Attaching the

Saw Guard Steel Mesh

Locate the

Saw Guard Steel Mesh (B3), turn the Saw Bench (A) upside down and remove the four

phillips screws & washers to each corner of the frame. Lay the Saw Guard Steel Mesh on top of the

frame and replace the phillip screws & washers to secure it in position. (See fig 4 & 4a).

Phillips screw & washer

M8 x 11mm hex bolt, washer & nut

Assembling the Sliding Carriage Table

Attach the two sliding carriage support arms (B) to the underside of the cast iron saw

bench (A) using four M6 x 50mm countersink heads & M6 nuts, secure using a 4mm allen

key (J). (See figs 6,7).

M6 Countersink Head

Secure the support arms with the

supplied 4mm allen key

Fig 4

Fig 4a

Fig 5

Fig 6

Fig 7

Fig 5a